How to Assemble a Plasmacar Toy

Author Info

This article provides the reader with clear and concise steps to assembling PlaSmart's PlasmaCar.

Steps

Push the wheels in at a 45 degree angle. When installed correctly, the rear wheels flare out from the body. Warning The rear wheel housing cannot be removed once locked into place.
Note: To use a steel hammer, place a small block of wood on the are to be struck.

Advertisement
The metal bearing should be seated securely in the body.
Note: Ensure that the bolt is attached to the steering wheel as shown.
Note: When the front wheels are assembled and resting on a flat surface, the smaller front wheels do not contact the ground.
This step is critical to operate your car use a 17 mm socket wrench to tighten the nut in the steering column AS TIGHT AS POSSIBLE. Fit the wrench onto the nut and turn until very tight. Alternatively, use the enclosed hex key and a screwdriver to tighten the nut AS TIGHT AS POSSIBLE.

Search

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

If the steering wheel becomes loose or fails to propel the PlasmaCar, the steering wheel nut may not have been tightened enough during assembly. Remove the cap from the steering wheel with a slot screwdriver and loosen the nut with the hex key. Repeat steps 7 and 8, securing the nut as tightly as possible.

Thanks
Helpful 0 Not Helpful 0
TROUBLESHOOTING: The rear wheels may detach from their housing if the PlasmaCar is subjected to overloading or impact. Fit the wheel into its housing so that the flat sides of the write clips contact the wheel housing. Snap the wheel back into place.

Thanks
Helpful 0 Not Helpful 0

Submit a Tip

All tip submissions are carefully reviewed before being published

Name

Please provide your name and last initial

Submit

Thanks for submitting a tip for review!

To prevent falls, the child should sit leaning slightly forward.

Thanks
Helpful 6 Not Helpful 1
Never use the PlasmaCar on a hill, steep slope, or over rough or uneven surfaces.

Thanks
Helpful 3 Not Helpful 2
The maximum load should not exceed 55 kg (120 lbs) on uneven surfaces, or 100 kg (220 lbs) on smooth surfaces.

Thanks
Helpful 4 Not Helpful 4
Adult supervision is strongly recommended at all times.

Thanks
Helpful 3 Not Helpful 4
Recommended for ages 3+

Thanks
Helpful 3 Not Helpful 4
When using the PlasmaCar, properly dispose of all plastic wrappings.

Thanks
Helpful 2 Not Helpful 4
Never use the PlasmaCar near steps, swimming pools, or vehicle traffic.

Thanks
Helpful 1 Not Helpful 6