How to Crimp Coax

Co-authored by Mantas Silvanavicius

Last Updated: August 28, 2023

Coaxial cable, commonly referred to as coax, guards against interference from outside noise by wrapping a single conductor with a tube of metal foil and mesh. This tube runs coaxially over the signal conductor. Maintaining the integrity of this shielding tube requires a special crimp termination method for coax. Use this wikiHow guide to learn how to crimp coax.

Steps

Download Article

1
Create a termination point.
- Cut off the end of the coax. Use small, sharp wire cutters. Create a squared off surface, rather than a beveled surface.
- Mold the end of the coax using your fingers. The cylindrical cable will be distorted by the pressure of making the square cut. Mold the end of the cable back into a cylinder.
These tools are available at hardware and electrical stores. Make sure that the end of the coax is flush against the wall or guide on the stripping tool. This will ensure proper strip length.

Advertisement
Smoothly spin the tool around the coax 4 or 5 times, or until you no longer hear the sound of metal being scored. Keep the rotation in 1 place on the cable. Do not apply any force that would pull on the cable insulation coating.
This strips the insulation to expose the wire. The tool will have made 2 cuts. Use your fingers to gently pull off the material nearest the end of the cable. This will expose the bare center conductor. Use your fingers to gently pull off the outer insulation that has been cut free. This will expose a layer of foil.
This will expose a layer of metal mesh.
Do not tear the layer of foil that is under the metal mesh. The foil must be left in place around the inner insulation. Bend the mesh all the way back so that it is molded over the end of the outer insulation.
F connectors are available at hardware and electrical stores. Make sure that the white inner insulation can be seen pressing against the front flange of the connector. If you can't see the insulation, jiggle and continue to push the coax and the connector together. Use straight pressure only. Do not twist the coax in the body of the connector.
8
Crimp the connection with a crimper. Place the F connector into a coax crimping tool. Coax crimping tools are available at hardware and electrical stores. Fully squeeze the tool handle and release. Remove the finished crimp connection from the tool.
- Gently pull on the wire to make sure it holds within the connector.

Community Q&A

Search

Add New Question

Question

What is the length of the insulation I need to remove from the end of the cable?

Community Answer

If it is a normal wire, then maybe 1/2 inch.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 2 Helpful 1