This article was co-authored by wikiHow staff writer, Hannah Dillon. Hannah Dillon is a Technology Writer and Editor at wikiHow. She graduated with a B.A. in Journalism from North Dakota State University in 2013 and has since worked in the video game industry as well as a few newspapers. From a young age Hannah has cultivated a love for writing and technology, and hopes to use these passions in tandem to help others in the articles she writes for wikiHow.
This article has been fact-checked, ensuring the accuracy of any cited facts and confirming the authority of its sources.
This article has been viewed 2,537 times.
Learn more...
Are you playing A Dusty Trip on Roblox, but you're not sure how to get started driving? If so, this is the guide for you! In this article, we'll go over how to build and start the car and how to drive; plus, we include all the Dusty Trip controls so you can start the game prepared.
How to Start Driving in a Dusty Trip
First, build the car. Once you're in the car, lower the parking brake and push R to start the car. Accelerate with W, and use A and D to turn the car left or right. Use S to slow down or drive in reverse. The car is your mode of transport and shelter on the road.
Steps
How to Start the Car
-
Build the car. Before you can start the car, you need to build it. To build the car, you must pick up and place the four tires, four doors, engine, and radiator. You must also add some fuel to the car. Optionally, you can add the hood, the trunk cover, the grill, the bumpers, and the headlights.
- To pick up items, press F. You can place them by pressing F when you have found the correct spot for them.
- The car parts are located in the following locations:
- Wheels: They're all located in the garage. One is by a shelf, while the others are stacked by some boards on the floor.
- Doors: They're also all in the garage. One is leaning against the shelf, while the other three are leaning against the wall.
- Engine: It's sitting on a table inside the garage.
- Radiator: It's laying on the floor by the table, underneath where the engine is.
- Fuel: There's fuel in the red fuel can in the garage.
- Hood, trunk cover, and bumpers: All four of these items are on the floor of the garage.
- Headlights: One is on the table, and one is on the shelf.
-
Get in the car. To get in the car, click on the door and pull it open, then press E.Advertisement
-
Lower the handbrake. The handbrake is located between the driver and passenger seats. To lower it, simply look down at it, then click on it and drag down to lower it.
-
Press R to start the car. You can now start driving.[1]
How to Drive the Car
-
Use W to drive forward. This is the same button you use to move your character forward. Once you reach your desired driving speed, you can let go of W, but press it again once you start to slow down.
-
Use A and D to turn left or right while holding W. These are the same buttons you use to make your character move left or right.
-
Use S to make your car slow down and/or drive in reverse. If you're driving forward, pressing S will make your car slow down. Once your car slows down enough, you'll start driving backward.
-
Use R to turn the engine on or off. You've likely already pressed R to start the car, but it can also be used to turn the car on or off.
-
Click the buttons to the right of the steering wheel for lights. The top button will turn on your headlights, and the bottom button will turn on the hazard flashing lights. You'll only be able to use the headlights if you installed them in the car.
- Headlights are crucial for driving safely at night. Otherwise, you won't be able to see hazards on the road.[2]
-
Click and pull on the parking brake to move it up or down. It's important to put up the parking brake when parked, or your car might roll away.
-
Certain items in the car cost Robux to use. This includes the radio to the left of the steering wheel (which can give you emergency resupplies) or the car radio (which is used to play music).
Expert Q&A
Tips
-
Placing the doors on the car can be tricky. The way you know if you've got it in the right spot is you see a prompt that says Press F to place instead of Press Z to attach part.Thanks