PDF download Download Article PDF download Download Article

Mites are a common parasite which can transmit bacteria and viruses between reptiles such as snakes. To get rid of mites on snakes, soak the snake in a povidone-iodine solution daily until the mites disappear. While the snake is soaking the first time, clean out the enclosure thoroughly by removing all substrates and use bleach to kill any harmful organisms. Check the snake daily for mites to ensure that its condition is improving and visit your local veterinarian if the snake deteriorates.

Part 1
Part 1 of 2:

Soaking the Snake

PDF download Download Article
  1. Find a plastic container that is large enough for your snake to fit comfortably into. Make sure that the lid has holes so that the snake can breathe while its soaking.[1]
    • If you cannot find a lid that already has holes in it, use an electric drill to punch holes through the plastic.
    • The lid prevents the snake from climbing out of the container.
  2. Remove the snake from its enclosure. Transfer it into the plastic container and keep the lid off for the time being.
    Advertisement
  3. Fill the container with a solution of warm water and povidone iodine. Combine 1 part povidone iodine and 10 parts warm water. Use water that is 75–85 °F (24–29 °C) so that it is a comfortable temperature for the snake. The amount of water that you use depends on both the size of the snake and the container. Use enough water so that the snake can bathe, but not too much that the snake could drown.
    • Povidone iodine is commonly sold under the name of Betadine.
  4. Place the lid on the container. Make sure that the container is close by so that you can keep an eye on the snake while its soaking.
  5. Check the chin, vent fold, and belly scutes for any dead or alive mites. Dip a cotton-tipped swab in mineral oil and use it to gently rub between the folds and scales to remove the mites.[2]
    • You can also dab the heat pits and eyes with mineral oil.
    • The vent fold is located on the underside of the tail, the belly scutes are the wide scales on the belly, and the heat pits are the small holes located between the eyes and nostrils.[3]
  6. Check the snake and the enclosure for mites daily. Soak the snake in the povidone-iodine solution every day until the mites are gone. If the mites persist or if the snake’s condition deteriorates, take the snake for specialist treatment with a veterinarian.
    • You will be able to tell if the snake's condition deteriorates if it has a loss of appetite, vomiting, starts breathing with an open mouth, or if it experiences changes in shedding.[4]
  7. Advertisement
Part 2
Part 2 of 2:

Cleaning the Enclosure While the Snake Is Soaking

PDF download Download Article
  1. While the snake is soaking, begin cleaning the enclosure. Pour the water out and discard any uneaten or leftover food. Clean out the food and water containers thoroughly.
    • Food and water must be disposed of to prevent it from being contaminated with cleaning chemicals.
    • You only need to clean the enclosure once to remove the mites, not every day.
  2. Take all of the substrate and porous items out of the enclosure. Place these into a plastic garbage bag and keep it outside until it can be discarded. Make sure it is out of reach from pets.
    • Wood is a porous item that cannot be cleaned adequately and must be removed.[5]
    • Whether you are getting rid of mites or simply doing a regular complete cleanup, don't reuse any portion of old substrate after it.
  3. Vacuum the floors and wall of the enclosure. Use the corner attachment to vacuum out the corners.[6]
    • This will help to remove mites, mite eggs, and mite feces.
  4. Use 1 part bleach to every 30 parts water and combine these in a clean bucket. Stir it to combine the water and the bleach.
    • If you use 1 US gal (3.8 L) of water, you will need to use 12 cup (120 ml) of bleach.
    • Make sure that you wear gloves when working with bleach.
  5. Use clean rags to wipe down all areas of the enclosure with the bleach solution. Make sure that the area you are working in is well-ventilated.[7]
    • Disinfecting the enclosure doesn’t kill the mites themselves, but it does kill the harmful organisms that are associated with the mites.
    • The bleach solution may also drown some remaining mites.
  6. Let the bleach solution sit in the enclosure for 10 minutes. Then use fresh water and a new clean rag to remove all of the bleach residue.[8]
  7. Place any rocks from the snake enclosure into a large pot. Fill the pot with water so that the rocks are completely submerged. Boil the rocks to kill any mites that may be on or inside them.[9]
  8. Purchase a no pest strip online or from your local pet store or veterinarian. Follow all of the directions on the label thoroughly by sealing the enclosure and then ventilating it correctly once the no pest strip has been removed. Keep the no pest strip in the enclosure for approximately 3 hours.
    • Never use a no pest strip while your snake is in the enclosure as it can be dangerous for the animal.
    • No pest strips release an insecticide vapor into the enclosure which will kill any remaining mites.[10]
  9. When both the enclosure and the snake have been cleaned, set up the enclosure again with a brand new substrate. Transfer the snake back into the enclosure and check it for mites daily.[11]
    • Paper towels are often a good substrate to use when you are trying to get rid of snake mites. This is because you will be able to easily spot any additional mites.
  10. Advertisement

Community Q&A

Search
Add New Question
  • Question
    My daughter has a boa constrictor, and its throat is swollen. Could it be an infection caused by a mouse scratching while swallowing? How can we treat it? He is quite irritated.
    FutureHow
    FutureHow
    Community Answer
    There are many causes for this. The best solution is to take the snake to an experienced vet. It might cost more, but you'll be saving the snake's life!
  • Question
    How do mites get on pet snakes?
    Bacon_hair8535 Noob
    Bacon_hair8535 Noob
    Top Answerer
    Most mites are introduced through new animals, or substrate, though you can also introduce them to your pet's enclosure on your hands and clothing. Pet stores and reptile expos are especially risky areas due to the large number of reptiles.
  • Question
    I have a ball python that won't eat. What do I do?
    Bacon_hair8535 Noob
    Bacon_hair8535 Noob
    Top Answerer
    Make an appointment with your vet anytime your snake refuses food for longer than a few weeks. Your vet will be able to determine if your snake is suffering from parasites, respiratory infections, or any other health problems that may limit his appetite.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement

Video

Tips

  • Snakes which have mites can show several different symptoms. These include small red or black bumps around the eyes, mouth, and jaw, frequent soaking, a reduced appetite, and irritability.[12]
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement

Warnings

  • Take your snake to the vet if its condition worsens or if you cannot get the mites under control. Although you will still need to thoroughly decontaminate the enclosure, the vet will be able to treat severe cases of mites using antiparasitic medication.[13]
Advertisement

Things You’ll Need

  • Plastic container with lid
  • Povidone-iodine
  • Cotton-tipped swabs
  • Mineral oil
  • Plastic garbage bag
  • Vacuum
  • Bucket
  • Bleach
  • Cleaning rags
  • Pot
  • No pest strip
  • New substrate

About This Article

Jeff Jensen
Co-authored by:
Reptile Specialist
This article was co-authored by Jeff Jensen. Jeff Jensen is a Reptile Specialist and the Owner of The Reptile Zone out of Bend, Oregon. With decades of experience with reptiles and wildlife, Jeff specializes in providing advice and guidance on proper reptile care. As a former science teacher and employee of the San Antonio Zoo and an accomplished herpetologist, Jeff’s dedication to knowledge and ethical pet trade practices led to The Reptile Zone being awarded a “Mark of Excellence” Award by Intrepid Marketing in 2018. This article has been viewed 87,891 times.
8 votes - 100%
Co-authors: 9
Updated: September 12, 2023
Views: 87,891
Categories: Snakes
Article SummaryX

If you need to get rid of mites on a snake, place the snake into a shallow plastic container and fill the container with a solution of warm water and providone iodine. Use enough water so the snake can bathe, but not so much that it could drown. Leave the snake to soak for 30 minutes to an hour, but stay nearby so you can watch the snake while it’s in the bath. Afterward, wipe away any remaining mites with a cotton swab dipped in mineral oil. Repeat the soaking process every day for up to a week. Keep reading to learn how to clean mites out of the enclosure while the snake is soaking!

Did this summary help you?

Thanks to all authors for creating a page that has been read 87,891 times.

Did this article help you?

Advertisement