How to Make a Solar System Model

Co-authored by Jessie Antonellis-John

Last Updated: December 11, 2024 References

There are eight known planets orbiting our sun, including Earth. Making a model is a fun introduction to this solar system, and a good art project for primary school science classes. This detailed example can take a few hours to make, but most of that involves waiting for paint or clay to dry.

How to Create a Solar System Model Project

Paint a cardboard box black to represent outer space. Gather 9 polystyrene or clay balls of different sizes to represent the sun and the planets. Paint them accordingly, then run a thread through their centers and tape the end to the box to hang the planets. Position the planets around the sun in the correct order.

Part 1

Part 1 of 3:

Making the Sun and Gas Giants

Download Article

The planets in your solar system model will hang down inside this box. You'll need to fit nine planets plus the sun into this, so make sure you have enough room. This should be at least as large as a men's shoebox, which is roughly 15" x 10" x 5½" (36 x 25 x 13 cm).
2
Paint the box black. Cover the inside of the box with black acrylic paint, along with the short outer sides. Set the box aside on newspaper to dry.
- For a more even background, trace the box onto black paper. Cut out the paper rectangle and tape it to the base of the box.
Advertisement
3
Gather five polystyrene balls. If possible, find these in three different sizes. They should all fit in the box with a little room left over, although they don't have to squeeze in all in a row. You'll need:
- One large ball to make the sun (maximum 4" / 10 cm across)
- Two medium balls to make Jupiter and Saturn (maximum 3" / 7.5 cm)
- Two small balls to make Uranus and Neptune (maximum 2" / 5 cm)
4
Choose your paints. Acrylic paint is your best option, since some other paints can dissolve polystyrene. Choose a variety of colors to paint your planets, including orange or gold, yellow, red, white, and dark blue.
- If you're not sure whether a paint works on polystyrene, check the label for brush cleaning instructions. If you can wash off the paint with water, the paint is water-based and safe to use. If you need to use a solvent like white spirit or turpentine, the paint is solvent-based and may dissolve polystyrene.^{[1]
  X
  Research source}
5
Paint the sun. Stick a long skewer into your largest polystyrene ball to hold it in place. Paint the entire surface with gold, yellow, or orange paint to make the sun. Place the skewer in a tall jug or stick the end in a polystyrene block and leave the ball to dry.
- A stenciling brush or other short-bristled brush will help you get the paint to stick into the nooks and crannies on your polystyrene ball. You might need to let the first coat dry and use a larger brush to paint over it for an even color.
- If the paint doesn't stick at all, cover the ball with a thin layer of spackle, let it dry, and paint over that.^{[2]
  X
  Research source}
6
Paint the large planets the same way. The two medium balls are the two largest planets, Jupiter and Saturn. These are called gas giants. They each have a diameter about ten times larger than Earth's, and are made mostly of a heavy layer of gas surrounding a rocky core.^{[3]
X
Research source} Skewer these and place them in a polystyrene block or separate jugs, so the wet painted surfaces don't touch.
- Jupiter's clouds form bands and spiral storms. Paint this planet with red, orange, and white paint, swirled into patterns.
- Saturn is ivory in color (a mixture of yellow and white paint) with white and light yellow streaks.
7
Paint the ice giants. Your last two balls will represent Neptune and Uranus, the smaller gas giants or "ice giants." About four times the size of Earth in diameter, these planets formed from balls of ice and heavy elements. Since then these materials have turned into a fluid core, surrounded by a layer of swirling gas.^{[4]
X
Research source}
- Paint Uranus a pale blue, made by mixing blue and white paint together. White clouds sometimes form over the solid blue atmosphere.^{[5]
  X
  Research source}
- Neptune is almost the same color as Uranus, but looks darker because it's farther away and receives less light. Paint it blue.
8
Add Saturn's rings. Find a drinking glass with an opening the same size as the ball you used to make Saturn. Put the glass down on gold or yellow construction paper and trace around it with a pencil. To make a ring shape, put down a larger glass over your pencil circle, and trace around that as well. Cut out this ring, then glue it around Saturn and let dry.
- Poke the hole through Saturn at an angle, so the rings will be tilted when the planet is hanging down. This will look better and give you a little extra room to arrange the planets.
- To cut out the ring, start by cutting out the larger circle. Fold the circle gently in half without creasing it, then cut around the smaller circle.

Part 2

Part 2 of 3:

Making the Rocky Planets

Download Article

1
Shape five rocky planets out of clay. You can use polymer clay, air dry clay, or homemade polymer clay substitute. Roll five small balls (maximum 1" / 2.5 cm across) using several colors of clay:
- Mercury is a brownish gray rock, with no cloud cover. You can make it out of red or gold clay instead for a prettier model.
- Make Earth out of blue clay for now.
- Make Venus out of pale yellow clay.
- Pluto is technically not a planet (it's too small), but it can sneak in anyway. Make it out of light brown clay, maybe with some charcoal mixed in to imitate its blotchy surface.
Use a large needle to pierce each rocky planet through the center. You'll run thread through this hole later to hang the planets inside your box.
3
Let the clay dry. Follow the dry instructions on the clay packaging. Air dry clay dries on its own, while other types of polymer clay needs a low-temperature oven to harden.
- For light colored clay, it's a good idea to set your oven about 10ºF (~5ºC) lower than the instructions recommend. This can take twice as long to bake, but the chance of breaking is lower.
Once the Earth clay is hard, paint on the continents with green acrylic paint.^{[6]
X
Research source}

Part 3

Part 3 of 3:

Assembling the Model

Download Article

Once the black paint on the box has dried, use a white paint pen or small brush to paint white dots onto the inside of the box.
2
Thread the polystyrene balls. Once the sun is dry, stick a skewer all the way through the ball, then remove it. Tape a piece of clear beading thread to the end of the skewer, and push it through the same hole. Repeat for each polystyrene ball.
- Each length of beading thread should be long enough to hang a planet from the "ceiling" of the box, when the box is on its side. Five or six inches (13–15 cm) should be enough.
Hold the end of the thread and withdraw the skewer. Knot the beading thread two or three times, then attach the knot to the polystyrene ball using a drop of glue from a hot glue gun.
Once the clay planets are dry, drop the clear thread through the holes you made earlier. Attach the thread with a hot glue gun, as you did with the larger planets.
5
Arrange the planets in the model. Put the box on its side and hold up the threads on the ceiling. Stagger the position of the planets at different heights (top/bottom) and depths (front/back) so you can fit them all in the box. The balls should go in this order:
- Sun
- Planets
  - Mercury
  - Venus
  - Earth
  - Mars
  - Jupiter
  - Saturn
  - Uranus
  - Neptune
- Dwarf Planets
  - Ceres
  - Pluto
  - Eris
  - Makemake
  - Haumea
EXPERT TIP

Jessie Antonellis-John
Math and Science Instructor
Jessie Antonellis-John is a Math and Science Instructor who teaches at Southwestern Oregon Community College. With over 10 years of experience, she specializes in curriculum development. Jessie earned her PhD in Teaching & Teacher Education from the University of Arizona, her Master of Education from Western Governors University, and her BS in Astrophysics from Mount Holyoke College. She’s also co-authored several peer-reviewed journal articles in professional publications.

Jessie Antonellis-John
Math and Science Instructor

Scale solar system models by size or distance from the Sun. When building a solar system model, scale the planets either by size or distance from the Sun. Pick a base unit, like Earth-Sun distance or Mercury's diameter, then scale up the rest. This helps show just how vast space really is!
Once you find an arrangement that looks good and fits in the box, mark the box at the ten points where you'll hang the sun and planets. Cut through the box at these points with a sharp knife, and feed the thread the planets are hanging from through each hole. Tape down the thread with strong tape and cut off the extra thread.
Trace the side of the box onto black paper and cut out the rectangle. Glue this over the top of the box to hide the tape. Now you're ready to display your solar system model.

Expert Q&A

Search

Add New Question

Question

How can I accurately represent the scale of the solar system in my model?

Jessie Antonellis-John
Math and Science Instructor
Jessie Antonellis-John is a Math and Science Instructor who teaches at Southwestern Oregon Community College. With over 10 years of experience, she specializes in curriculum development. Jessie earned her PhD in Teaching & Teacher Education from the University of Arizona, her Master of Education from Western Governors University, and her BS in Astrophysics from Mount Holyoke College. She’s also co-authored several peer-reviewed journal articles in professional publications.

Jessie Antonellis-John

Math and Science Instructor

Expert Answer

The tricky thing with solar system models is showing the huge differences in sizes and distances realistically. You have to decide if you want to focus on planet sizes relative to each other, or the distances between them. It's really hard to nail both in one small model. My advice would be to first pick a unit of measurement as your scale baseline. For distances, use the Earth-Sun distance as the unit. For sizes, start with a small planet like Mercury as the unit, then scale up from there. Remember the differences get extreme fast when you scale up, so stick clearly to the scale you set. It's all about choosing a consistent scale and units to work from in order to get those proportions right.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 4 Helpful 11
Question

What colors are the planets?

TomPN

Top Answerer

Mercury is grey, Venus is a pale yellow-white, Earth is blue and green, Mars is red-orange, Jupiter has bands of brown and white with the Great Red Spot, Saturn has bands of white and yellow, Uranus is a featureless blue-green, and Neptune is dark blue with occasional white clouds. Look up pictures of them on the internet for more detail.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 22 Helpful 126
Question

How do I make the ring for Saturn?

Community Answer

You could use a CD and cut it and/or paint it to size. You can also use card stock.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 44 Helpful 113

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Things You'll Need

Men's shoe box or larger cardboard box
Black construction paper
Gold construction paper
Acrylic paint in various colors
White paint pen (optional)
Clear beading wire
Hot glue gun
Bamboo skewers
Polymer clay
Large needle
Polystyrene balls in three sizes
Several tall jugs or one polystyrene block
Sticky tape
Two drinking glasses, one slightly larger than the other

Tips

This model isn't trying to accurately show the size differences between planets. That's hard to do in a shoe box, since over a million Earths could fit inside the sun!^{[7]
X
Research source} If you find it easier, feel free to make all the planets out of one material (polystyrene or clay), even if you only have two or three different sizes.

Thanks
Helpful 0 Not Helpful 0
Not only Saturn has rings, but so do all gas giants (Jupiter, Neptune, and Uranus). The latter has vertically rotated rings.

Thanks
Helpful 3 Not Helpful 1
It is more complicated if you want to add the satellites or "moons" because each planet has a specific amount:
- Planets:
  - Jupiter = 63
  - Saturn = 62
  - Uranus = 28
  - Neptune = 16
  - Mars = 2
  - Earth = 1
- Dwarf Planets:
  - Pluto = 5
  - Haumea = 2
  - Eris = 1
  - Makemake = 1
Thanks
Helpful 0 Not Helpful 0