PDF download Download Article
Address this error message with the help of this guide
PDF download Download Article

If you’re driving your Mercedes-Benz and see the “Stop Vehicle Leave Engine Running” message on your dash, it may be a problem with your battery’s charge. While pulling over and waiting for a few minutes usually makes the message go away, it may stay lit up if other components are to blame. Keep reading, and we’ll let you know what to do when this error appears and how to troubleshoot what’s causing the issue.

Things You Should Know

  • The “Stop Vehicle Leave Engine Running” message means your vehicle’s battery has dropped below 12 volts and that there’s a problem with the charging system.
  • Stop your vehicle in a safe area and turn off any electronics. Leave your engine running for 10–30 minutes until the message disappears.
  • If the message remains, check the battery, alternator, and wiring in your vehicle and have them replaced if they’re old or damaged.
Section 1 of 2:

What does “Stop Vehicle Leave Engine Running” mean?

PDF download Download Article
  1. If the battery in your Mercedes-Benz drops below 12 volts, then the message may appear on your dashboard. This usually means that the battery doesn’t have enough power to start your vehicle and isn’t getting properly charged.[1]
    • The “Stop Vehicle Leave Engine Running” message appears on Mercedes-Benz models made after 2015, including the C180, C250, C43 AMG, C200, E300, GLC300, and C300.[2]
    • The Fix: When you see the “Stop Vehicle Leave Engine Running” warning, find a safe place to pull over and stop your vehicle. Turn off your lights, AC, and anything else drawing power. Leave your engine running for about 10–30 minutes until the message disappears.[3]
    • Is it safe to drive?: Continuing to drive with the warning message could lead to engine damage, so it’s best to stop until the message disappears.
  2. Advertisement
Section 2 of 2:

Causes and Fixes for “Stop Vehicle Leave Engine Running”

PDF download Download Article
  1. As car batteries get older, they aren’t able to hold a charge as effectively. When either the main or the auxiliary battery in your vehicle fails, the “Stop Vehicle Leave Engine Running” warning may appear on your dashboard.[4]
    • Diagnosis: Inspect the battery for damage or leaks. Test the battery with a multimeter by touching the positive and negative probes to the matching terminals. If the battery is around 12.6 V, start your vehicle and test the battery again. If the reading drops below 10 V, then the battery is bad.
    • The Fix: Replace the old battery. Batteries vary in price depending on the size and power, but they usually cost between $50–250 USD.
    • Mercedes batteries usually last around 3–5 years before you need to replace them.
    • Today, Mercedes vehicles are very voltage sensitive, so it's important not to use a cheap replacement battery. Only use OEM (Original Equipment Manufacturer) batteries, or OEM-equivalent batteries.
  2. When you turn on your headlights or interior lights, or when you plug multiple chargers and accessories into your vehicle, it draws power from the battery. If you drain too much power, then the warning message will show up.[5]
    • Diagnosis: Charge your car battery. Unplug chargers, turn off the radio, shut off any lights in your car, and start driving. If the message doesn’t reappear, then the accessories may be the issue.
    • The Fix: Only plug in accessories and turn on your lights when the engine is running. Unplug any chargers you aren’t using. Try to avoid using the radio and other electronics during shorter drives.
  3. A parasitic drain is when a faulty electrical component in your vehicle slowly draws power when it’s not supposed to. Because the drain takes power from your battery, it could trigger the “Stop Vehicle Leave Engine Running” error.[6]
    • Diagnosis: Unplug any devices and make sure lights are turned off before charging your battery completely. Locate the parasitic drain by testing the battery with a multimeter while removing one fuse at a time from the fuse box. If the voltage drops significantly after pulling a fuse, the circuit is the source of the drain.
    • The Fix: After figuring out the circuit causing the problem, have your vehicle inspected by a professional mechanic because any part along the circuit could be the issue.
  4. The alternator connects to your engine and charges your battery while your vehicle is running. When the alternator doesn’t have a solid connection to your engine or battery, then the error message can appear on your dash.[7]
    • Diagnosis: If you have difficulty starting your engine, smell burning wires, hear a whining noise, or have trouble working other electronics, then the alternator is most likely the culprit.
    • The Fix: Have a mechanic replace the alternator. If you’re confident working on your own vehicle, disconnect the battery and change the alternator yourself.
  5. The voltage regulator is a piece that connects to the alternator to limit how many volts it produces. When the voltage regulator breaks or starts malfunctioning, it can trigger the “Stop Vehicle Leave Engine Running” message.[8]
    • Diagnosis: Listen for misfiring and stalling when you drive your car. If the error message appears right when you start your vehicle, then it could be the voltage regulator.
    • The Fix: Because the voltage regulator is usually located inside your vehicle’s alternator, have a mechanic replace the entire alternator.
  6. If electrical wires are old or corroded, they may not be able to form a solid connection to your battery. When any of these connections fail, the warning light may illuminate on your dashboard.[9]
    • Diagnosis: Inspect any visible wires for damage or corrosion. Hold the probes of a multimeter against the ends of any suspect wires and test for resistance. If the resistance is greater than 1 ohm, then the wiring is bad.[10]
    • The Fix: Replace any faulty wires that you find. If you’re unable to find or replace the wires on your own, take your vehicle to a mechanic for repairs.
  7. The serpentine belt connects to your engine and powers all the accessories in your vehicle, like the alternator and other electronics. If the belt slips off the pulleys or breaks, then it won’t provide enough power to your vehicle and cause an error message.[11]
    • Diagnosis: Look for your serpentine belt attached to the side of your engine. Check the condition of your serpentine belt for any cracks or damage.
    • The Fix: Replace the damaged belt.
  8. Your transmission is responsible for shifting between gears, but it can cause problems if the fluid inside starts to overheat. When the fluid gets too warm, it can cause electronic malfunctions and display the “Stop Vehicle Leave Engine Running” message.[12]
    • Diagnosis: If you notice a burning smell, slipping gears, unusual noises, or a high transmission temperature gauge while you’re driving, then the transmission is typically the issue.[13]
    • The Fix: Add transmission fluid to top off the levels if they’re low. If you notice fluid leaking under your vehicle, take it to a professional to diagnose and repair it.
  9. Advertisement

Expert Q&A

Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement

Tips

  • If you’re having trouble diagnosing the problem or if you feel uncomfortable working on your vehicle, take it to a trusted mechanic.
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement

Warnings

  • Driving while your vehicle says “Stop Vehicle Leave Engine Running” could damage your engine. Stop and let the battery charge and fix the underlying issue as soon as possible.[14]
Advertisement

You Might Also Like

Reset Traction Control Light Reset a Traction Control Light (TCS)
Reset Steering Angle Sensor Without Scanner Reset Your Steering Angle Sensor Without an OBD-2
Bypass Limp Mode Get Out of Limp Mode: 5 Ways to Bypass, Signs, & More
Fix a Locked Steering WheelFix a Locked Steering Wheel
Anti Theft System Won't Let My Car StartWhat to Do If Your Car’s Anti-Theft System Prevents It from Starting
Change an Oxygen SensorChange an Oxygen Sensor
Reset Maintenance LightQuick and Easy Steps to Reset the Maintenance Required Light
Open a Hood with a Broken LatchOpen a Hood with a Broken Latch
Reset Gas Gauge Needle Reset a Gas Gauge Needle
Fix a Cigarette Lighter in a CarFix a Cigarette Lighter in a Car
Open the Hood of a Vehicle Unlock the Hood of Your Car
What Transmission Do I Have Identify Your Vehicle’s Transmission
Determine Gear RatioDetermine Gear Ratio
Reset Camshaft Position SensorResetting a Camshaft Position Sensor: Everything You Need to Know
Advertisement

About This Article

Jason Shackelford
Reviewed by:
Auto Technician
This article was reviewed by Jason Shackelford and by wikiHow staff writer, Hunter Rising. Jason Shackelford is the Owner of Stingray Auto Repair, a family owned and operated auto repair shop with locations in Seattle and Redmond, Washington. He has over 24 years of experience in auto repair and services, and every single technician on Jason’s team has more than 10 years of experience. This article has been viewed 53,069 times.
7 votes - 94%
Co-authors: 3
Updated: June 21, 2024
Views: 53,069
Thanks to all authors for creating a page that has been read 53,069 times.

Did this article help you?

Advertisement