3 Techniques for Cutting Your Own Side Bangs

You’ve been thinking about cutting your own side swept bangs for a while, but do you dare? Can you get the flattering fringe you’re longing for without an expensive salon visit? Absolutely! Learn how to be your own hairstylist with these step-by-step instructions for cutting side sweeping bangs using scissors or a razor. Plus, we even have directions for cutting naturally curly bangs. Your side swept bangs will look so fabulous, no one will ever guess that you cut them at home!

Method 1

Method 1 of 3:

Cutting Side Bangs with Scissors

Download Article

1
Section the front of your hair in a triangle starting at the crown. Part your dry hair down the center with a rat tail comb, then find the spot where your head starts to slope forward, approximately 2 inches (5.08 cm) back from your hairline. Make a diagonal downward part on each side of this point, using the arch of your eyebrows as a guide to get the correct angle. Comb this triangle section of hair forward.^{[1]
X
Research source}
- Make sure your hair is completely dry.^{[2]
  X
  Expert Source
  
  Yan Kandkhorov
  Hair Stylist
  
  Expert Interview. 28 January 2020.} Cutting wet hair won't give you the accuracy you need because wet hair dries shorter and to a different shape.
- Tie the rest of your hair back to keep it out of the way.
Make a horizontal part in the bang hair with a rat tail comb, sectioning it into an upper and lower half. Clip the upper half out of the way on top of your head, as you’ll be trimming the lower half of your bang hair first.^{[3]
X
Research source}

Advertisement
3
Pinch the hair between two fingers to mark the length you want. Pull your lower bang hair straight down in front of your face, but don’t tug on it. Select a reference point on your face that’s the length you’d like your shortest bang piece to be. Pinch your hair in that spot, holding it between the second and third fingers of your non-dominant hand. This will serve a guide for cutting.^{[4]
X
Research source}
- Some people use the bottom of their nose as a reference point. Others prefer a longer length and use the middle of their lips as a reference point.
- If you’re uncertain, start with a longer length. You can always take off more hair, but you can’t put it back once it’s cut.
4
Pull your hair to the opposite side of how you’ll wear your bangs. With your fingers still pinching your hair at the reference point, sweep your bangs over in the opposite direction of how you’ll part your hair.^{[5]
X
Research source}
- Once your hair is cut, it will fall to the other, correct side of your face with a sweeping downward angle.
5
Cut off the hair right below your fingers. Hold your hair close to your face and make a straight parallel cut. Release your hair; the shortest part of your bangs will reach the reference point on your face. Comb this hair over to the correct side, the way you intended to wear it.^{[6]
X
Research source}
- Special styling shears will give you the best results, as they're sharper and designed for cutting hair. Otherwise, make do with a sharp pair of regular scissors.^{[7]
  X
  Research source}
Repeat the process you used to cut your lower bangs: find your reference point, pinch your hair, and pull it to the opposite side of how you’ll wear your bangs. Make a straight, parallel cut beneath your fingers.^{[8]
X
Research source}
Comb the upper and lower bang sections together and pull them in front of your face. Hold your bangs near the bottom, pinching the hair horizontally between the second and third fingers of your non-dominant hand. Pull your bangs slightly outward so they aren’t touching your face.^{[9]
X
Research source}
8
Blend the bangs by point cutting the ends with small vertical clips. Hold the scissors vertically and snip the ends of your bangs by making tiny upward clips with the tips of the scissors.^{[10]
X
Research source} Keep the clips shallow, only inserting the blades about ¼ - ½ inch (.64 - 1.27 cm) deep. When point cutting, the goal is to remove bulk rather than length.^{[11]
X
Research source}
- Cutting at an angle would remove chunks of hair and change the shape of your bangs; make sure to keep the scissors straight and vertical.
Spritz your bangs with water and comb them in the direction of your part. For a sleek and sexy look, finger comb through your bangs as you blow dry them. Shuffle your hair a bit from left to right as you comb your fingers downward. For a fuller, softer side sweep, use a round brush as you blow dry; a round brush will give your bangs more curl.^{[12]
X
Expert Source

Noël Reid-Killings
Celebrity Hair Stylist

Expert Interview. 25 November 2020.}

Method 2

Method 2 of 3:

Cutting Side Swept Bangs with a Razor

Download Article

1
Choose a sharp, single-blade razor. A styling razor is recommended, although some DIY folks make do with a disposable shaver. Just ensure that your razor is very sharp and has a single blade. Using a dull tool or one with multiple blades can cause split ends.^{[13]
X
Research source}
- Razor-cutting extremely coarse hair might not be your best bet, as it can cause split ends.
Comb your hair forward over your face. Find the spot where your head starts to slope forward, approximately 2 inches (5.08 cm) from your hairline. Make a diagonal downward part on each side of this center point, using the outside ending point of your eyebrows as a guide to get the correct angle. Tie the rest of your hair back.
At your natural part line, separate the bang hair so there's a piece of hair on the left and a piece on the right. Clip the smaller section of bang hair out of the way.^{[14]
X
Research source}
4
Make small razor strokes to cut the larger section of hair at a slant. Hold the bigger section of bang hair tautly between the fingers of your non-dominant hand. Starting at the bottom of your nose, stroke the razor against your hair to remove small bits at a time.^{[15]
X
Research source} Cut your bangs at an angle that slants downward towards your jaw.^{[16]
X
Research source}
- Make small up-and-down movements as you cut.^{[17]
  X
  Research source} Some confident stylists use longer, sweeping motions, but it’s safer to take your time if you’re new to cutting bangs.
- Keep your fingers out of the way by sliding them down your hair as you cut. Styling razors are extremely sharp, so be careful.
- Most professional stylists like to wet down bangs before cutting with a razor, as a razor can tug on dry hair. However, it’s easier for beginners to get the length they want if they cut their bangs dry, since wet hair will shorten as it dries.
5
Check your bang length and graze the tips with a razor to remove bulk. Make sure you’re happy with the angle and length of your cut. For a wispier, more texturized look, remove excess bulk by very lightly running the razor downward over small pieces of hair, starting about 1 inch (2.54 cm) above the end of your bangs.^{[18]
X
Research source}
- Remember that you’re trying to remove bulk, not length, so don’t apply a lot of pressure on the razor.
Unclip the uncut bang hair, then comb both sections of bang hair in front of your face. Grasp the piece of long bang hair that’s next to the cut bang hair, holding a ½ inch (1.27 cm) piece of it between the fingers of your non-dominant hand. Use the razor to cut it the same length as the short hair beside it.^{[19]
X
Research source}
7
Cut the smaller section of bangs at a downward angle. Trim these bangs so they match the angle of the bangs you cut earlier.^{[20]
X
Research source} See if your bangs are symmetrical by using both hands to hold a bang piece from each side. Slide your fingers downward; if your bangs match, your fingers will slide off both pieces of hair at the same time.^{[21]
X
Research source}
- Remember, you can always trim shorter, but you can’t add length once the hair is cut. Take your time.
- Remove excess bulk by lightly grazing the blade downward over small pieces of hair, starting about 1 inch (2.54 cm) above the end of your bangs.

Method 3

Method 3 of 3:

Cutting Naturally Curly Side Bangs

Download Article

1
Air dry your hair or use a blow dryer with a diffuser. Squeeze excess moisture out of your hair by scrunching it with a t-shirt. Add a bit of leave-in conditioner or curl cream to your damp hair for best results. Wait for it to dry, or use a blow dryer with a diffuser attachment; diffusing your hair minimizes frizziness.^{[22]
X
Research source}
- Starting with freshly washed and dried hair makes the curls easier to separate.
2
Section your bang hair with a part that goes from ear-to-ear. Create a part that runs parallel to your hair line. Begin the part at the front of one ear and curve it over your head to the top of the other ear. You can do this with your fingers or with a wide-tooth comb. Tie the rest of your hair back.^{[23]
X
Research source}
- Dry-cutting curly hair is recommended because the curls shrink a lot once they dry.^{[24]
  X
  Research source} It’s also easier to identify and separate ringlets when your hair is dry.
3
Cut curl groupings individually. Finger-comb your hair, separating the curls into their natural ringlets or groupings. Use styling shears or sharp scissors to cut the shortest curl grouping, holding the ringlet lightly between your fingers–you don’t want to stretch it out, or it will be difficult to tell how short the curl will be.^{[25]
X
Research source}
- To decide how short to cut, think about how you plan to wear your hair. Do you want diagonal bangs that rest mainly on your forehead, or do you want them to be long enough to sweep behind your ear?
- For shorter diagonal bangs, make your shortest curl even with the bottom of your eyebrows. For longer side bangs that blend into long hair, make the shortest curl even with the bridge of your nose.^{[26]
  X
  Research source}
- When in doubt, opt for longer bangs. You can always shorten them later.
4
Continue to cut curl groupings so they slant downward. The longest ringlet will be on the opposite side of your face from your shortest ringlet.^{[27]
X
Research source} The angle doesn’t need to be completely uniform; you may like the more natural appearance of having some ringlets be slightly longer or shorter. As long as the overall shape of your bangs is at a downward slant, it will look great.
- Wear your new diagonal bangs for a day or two, then wash your hair before deciding whether to shorten your bangs further. You'll have a better idea of how your bangs naturally lay if you live with them for a few days first.^{[28]
  X
  Research source}

Expert Q&A

Search

Add New Question

Question

Would a full fringe work for a round, heart-shaped face with a small forehead? What other styles might look good?

Ashley Adams
Professional Hair Stylist
Ashley Adams is a Licensed Cosmetologist and Hair Stylist in Illinois. She completed her Cosmetology education at John Amico School of Hair Design in 2016.

Ashley Adams

Professional Hair Stylist

Expert Answer

It doesn't hurt to try! A side swept fringe just may work for you. You could also try a low bun with a long, side swept fringe, or voluminous waves.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 13 Helpful 23
Question

When I go to the salon I request that they cut my hair in a rounded side fringe. However, they always make my hair follow my eyebrow and that isn't what I want. How can I better explain to them the style I'm trying to achieve?

Community Answer

Try telling them you want face framing bangs instead of straight. And also explain exactly as you have done here, saying what you do not want as much as what you do want.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 12 Helpful 41
Question

How do I cut my side swept bangs when I have short hair?

Community Answer

You could gel your hair back and then leave one piece out. Cut that piece a little shorter and gel it to the side, then take the rest of your hair and comb it out.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 9 Helpful 13

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Tips

Keep a steady hand. An uneven cut could ruin your fringe. If caffeine gives you a hand tremor, avoid caffeinated beverages for a few hours before cutting your bangs.^{[29]
X
Research source} On the flip side, if you're addicted to caffeine, abstaining may also cause your hands to shake.^{[30]
X
Research source} Be sure to find the right balance before attempting this cut.

Thanks
Helpful 0 Not Helpful 1
Ask if your salon offers free bang trims. Many do!

Thanks
Helpful 2 Not Helpful 3

Submit a Tip

All tip submissions are carefully reviewed before being published

Name

Please provide your name and last initial

Submit

Thanks for submitting a tip for review!

Warnings

Work slowly; if you cut too quickly, you may end up taking out chunks of your bangs.

Thanks
Helpful 2 Not Helpful 0
Use caution when cutting with a razor or scissors. Remember to keep your fingers out of the way to avoid injury.

Thanks
Helpful 1 Not Helpful 0