PDF download Download Article PDF download Download Article

Did you lose your stylus? Or are you just looking for more accuracy when drawing on your tablet or touch screen? Before you go out and spend money on a new stylus, check out this handy guide that will teach you how to create your own DIY stylus pen for just about any type of screen, including your Android, iPad, and Nintendo 3DS!

Method 1
Method 1 of 4:

Know Your Touch Screen

PDF download Download Article
  1. There are several different types of touch screens and your homemade stylus may not work with all of them.[1]
    • iPhones, iPads, Androids, Kindles, and many other smartphones and tablets have a capacitive touch screen, which needs an electrical conductor (like the human body) to register where contact is made.
    • Nintendo DS, The 3Ds, the Nook, and some other phones and e-readers use resistive or infrared touch screens, which only require pressure to register contact. You can use just about anything as a makeshift stylus--just be careful not to scratch the screen.
  2. Watermark wikiHow to Make a Stylus
    Touch the screen with the tip of a pen cap. If the device responds, it has a resistive or infrared touch screen. If nothing happens, the screen is inactive.
  3. Advertisement
Method 2
Method 2 of 4:

Making a Stylus with a Sponge (Capacitive Screen)

PDF download Download Article
  1. Find a clean dish sponge (not a scour pad) and a ballpoint pen with a removable tip.
    • A cheap, plastic pen works best, as long as you can easily pull off the plastic tip and remove the ink.
    • A slightly see-through pen can make it easier for you to see what you are doing.
  2. Watermark wikiHow to Make a Stylus
    You can approximate this measurement by holding the pen against the sponge and marking the measurement with a marker, or you can just eyeball it.
  3. Watermark wikiHow to Make a Stylus
    Anything abrasive can scratch and damage your screen. You only want the actual sponge part.
  4. Watermark wikiHow to Make a Stylus
    Some sponges come with soap already added, so to be safe rinse the sponge in warm water. Squeeze out all of the water and let the sponge dry.
  5. Watermark wikiHow to Make a Stylus
    You should be left with the empty base of the pen.
    • You should be able to pull the tip off with just your hand. If you have difficulty, try using a pair of needle-nose pliers.
  6. Watermark wikiHow to Make a Stylus
    Pinch the sponge to make it smaller and push it into the base of the
  7. Use your finger to feather and break up the fibers of the sponge.
  8. Watermark wikiHow to Make a Stylus
    Your fingers need to be touching the base of the pen that is in contact with the sponge. If you hold the hollow part of the pen, the electromagnetic current won't pass through the sponge and the touch screen won't register the touch of the stylus.
  9. Advertisement
Method 3
Method 3 of 4:

Making a Stylus with Aluminum Foil (Capacitive Screen)

PDF download Download Article
  1. You'll need about a foot of aluminum foil, tape of any kind, and an unsharpened pencil. You may also need a sharp knife to whittle your pencil.[2]
    • If you don't have a pencil, you can substitute a pen, a chopstick, a dowel--anything pen-shaped. Pencils or other wooden objects work best, however, as you may want to cut your stylus to have an angled tip.
  2. [3] You are not sharpening the pencil tip as though you are going to write with it. The angled tip should still have a surface area of at least four millimeters, about the size of a pencil eraser or the very tip of your finger. Many capacitive touch screens will not register the touch of anything smaller.[4]
    • The stylus will work without this step, but you will have to hold it straight up and down. This will make it more comfortable to hold.
    • Always be careful when handling a knife--remember to cut away from your body. Never pull the knife toward yourself.
  3. Watermark wikiHow to Make a Stylus
    Fold the aluminum foil neatly over the tips.
    • If you are using a pen, keep the cap on the pen when you wrap it.
  4. Watermark wikiHow to Make a Stylus
    It should be smooth and flat on the tip. You don't want any crinkles or bumps.[5]
    • If your tip is not flat, your stylus may not work.
  5. Watermark wikiHow to Make a Stylus
    This will keep the foil in place.
  6. Watermark wikiHow to Make a Stylus
    This will protect your screen from getting scratched by the aluminum foil.
  7. Watermark wikiHow to Make a Stylus
    If it isn't working, try to flatten your tip even more. Remember that you want the tip to be at least the size of an eraser or else it may not be acknowledged by your touch screen.
  8. Advertisement
Method 4
Method 4 of 4:

Making a Stylus out of a Wooden Chopstick (Resistive or Infrared Screen)

PDF download Download Article
  1. You'll need a single chopstick, sandpaper, and something to sharpen the wood. A hand-operated pencil sharpener is the easiest way, but you could also whittle the tip with a sharp knife if you don't have a pencil sharpener.[6]
    • Try not to use an electric pencil sharpener--it may break.
  2. Watermark wikiHow to Make a Stylus
    Sharpen it less than you would a pencil--you want it to look more like a blunt pencil tip.[7]
  3. Watermark wikiHow to Make a Stylus
    A sharp tip may damage your touch screen (or you). Rub the tip with the sandpaper until it is blunt. It should not be painful if you press it into your skin.
    • Sand any rough edges of the chopstick as well so you don't get splinters. [8]
  4. Watermark wikiHow to Make a Stylus
    A few layers of tape wrapped around the stylus may make it more comfortable to hold.
    • Remember: this stylus will not work on an iPhone, Android, Kindle Fire, or other device with a capacitive screen.
  5. Advertisement

Community Q&A

Search
Add New Question
  • Question
    Can I make a stylus using cotton?
    Community Answer
    Community Answer
    It should be possible if you roughly follow the instructions for the sponge method. Just remember that, if you have a capacitive screen, your fingers will need to be close to the screen when you use your stylus.
  • Question
    Can you use duct tape instead of aluminum foil?
    Community Answer
    Community Answer
    No. Duct tape is an insulator and would not let the energy from your finger transfer to the screen. The material needs to conduct energy.
  • Question
    Will the chopstick work for the Nook?
    Community Answer
    Community Answer
    The Nook has a resistive touch screen which only needs pressure to register contact, so yes, a chopstick will work.
See more answers
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement

Video

Reader Videos

Tips

  • If you don't have a sponge, use a cotton swab or Q-tip as an alternative. Add a small drop of water to dampen it. Squeeze excess water over the sink before inserting or taping it to a pen.
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement

Warnings

  • Be careful whenever using a knife. Always push the knife away from your body when carving or whittling - don't pull it towards yourself!
Advertisement

Things You'll Need

Making a Stylus with a Sponge

  • Clean sponge
  • Ballpoint pen with a removable tip
  • Scissors

Making a Stylus with Aluminum Foil

  • Aluminum Foil
  • Tape (Scotch, duct, etc.)
  • An unsharpened pencil
  • Sharp knife (optional)

Making a Stylus with a Chopstick

  • Chopstick
  • Sharp knife or Hand-held Pencil Sharpener (not electric)
  • Sandpaper
  • Washi tape, paint, or markers for decoration

You Might Also Like

Repair a Scratched or Finger Printed Monitor ScreenRepair a Scratched or Finger Printed Monitor Screen
Clean a Laptop Screen with Household ProductsSafely Clean a Laptop Screen Using Household Products
Make a Pen Stylus
Connect Two MonitorsConnect Two Monitors
Scan Documents Into PDF6 Quick Ways to Scan Documents to PDF on Mobile or Desktop
Make a Stylus for iPad
Scan Multiple Pages Into One PDF FileScan Multiple Pages Into One PDF File
Connect a Microphone to a Computer Connect a Microphone to a Mac or Windows Computer
Email a Scanned Document Email a Scanned Document as a PDF
Scan PhotosScan Photos
Digitally Scan 35mm SlidesDigitally Scan 35mm Slides
Scan a Book Scan a Book to PDF on a Computer, iPhone, or Android
Remove a Device from HP Smart App on a PC Remove a Device from the HP Smart App
Install a Fingerprint ReaderInstall a Fingerprint Reader
Advertisement

About This Article

Tested by:
wikiHow Video Team
wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, 65 people, some anonymous, worked to edit and improve it over time. This article has been viewed 1,391,622 times.
How helpful is this?
Co-authors: 65
Updated: June 24, 2024
Views: 1,391,622
Article SummaryX

To make a stylus for your smartphone or tablet, start by cutting a finger-tip sized circle out of a dish sponge. If your sponge has an abrasive side for scouring, cut this off to avoid scratching your screen. After that, wash and dry it to get rid of any dirt. Then, remove the plastic tip and interior of a ballpoint pen. Pinch the sponge you cut out and push it into the base of the pen. Leave about ¼ of an inch of sponge sticking out to touch your screen with. For more tips, including how to make a stylus for a Nintendo DS or e-reader, read on!

Did this summary help you?

Thanks to all authors for creating a page that has been read 1,391,622 times.

Reader Success Stories

  • Vihar Kontra

    Vihar Kontra

    Mar 5, 2017

    "Made a small aluminum foil ball. Rubbed it nicely on tiles to get a flat surface. Fixed the ball at the end of a..." more
Share your story

Is this article up to date?

Advertisement