PDF download Download Article
Expert advice for fixing a laptop key
PDF download Download Article

This wikiHow teaches you how to attempt to fix an unresponsive keyboard key. If cleaning the key's slot and re-seating the key doesn't fix your key's problems, you may need to replace the key altogether.

Part 1
Part 1 of 3:

Preparing to Repair or Replace a Key

PDF download Download Article
  1. In order to attempt to repair a key on your laptop's keyboard, you'll need the following items:
    • Prying item - Something plastic, such as a credit card or a spudger, is best; you can use a butter knife or a flathead screwdriver in a pinch.
    • Q-tip - Used to clean grit and dust from the area surrounding the key.
    • Toothpick - Used to clean grooves around the key.
    • Tweezers - Used to pull away pieces of the key carriage. Not necessary for all computers, but helpful.
    • A container - Used to store the pieces of the key while you make the repairs. You can use a bowl, a plastic bag, or any similar such item here.
  2. Most keyboard keys are comprised of three parts: the key cap (which is the key itself), the key carriage (a flat piece of plastic on which the key sits), and the key pad (a piece of rubber that sits between the key and the carriage).
    • Most MacBook keys don't have the rubber key pad.
    • Many computers' key carriages are comprised of two or more pieces of plastic that nest together.
    Advertisement
  3. It's best to find a flat, clean, indoor area, such as a kitchen table or a counter, on which to perform your repairs.
  4. Turn off and unplug your computer. Make sure that your computer is off and not plugged into a power source when your go to remove a key.
    • You may want to remove the computer's battery as well, if possible.
  5. Ground yourself before attempting any repairs. While the chances of you damaging your computer's internals with static electricity via a key repair are slim, grounding only takes a second and is good practice for dealing with electronics in general.
  6. Advertisement
Part 2
Part 2 of 3:

Repairing a Key

PDF download Download Article
  1. Using a damp q-tip, swab the area between the key that you want to replace and the surrounding keys. This will usually constitute moving the q-tip in a square around the key.
    • If your keyboard is sticky or grimy, you can use a small amount of isopropyl alcohol on the q-tip to help remove the grime.
  2. Use the toothpick to scrape gently the space below and around the key. This will help prevent any loose dust or grit from falling down into the key's slot.
  3. Pry up the bottom of the key at a 45-degree angle, then pull it away from the keyboard and set it somewhere safe.[1]
    EXPERT TIP
    Mobile Kangaroo

    Mobile Kangaroo

    Computer & Phone Repair Specialists
    Mobile Kangaroo is a full service repair shop and Apple Authorized Service Provider headquartered in Mountain View, CA. Mobile Kangaroo has been repairing electronic devices such as computers, phones, and tablets, for over 19 years, with locations in over 20 cities.
    Mobile Kangaroo
    Mobile Kangaroo
    Computer & Phone Repair Specialists

    You can usually remove, clean, and restore unresponsive keys. A lot of the time, the key is just dirty and needs proper cleaning to work again. If that doesn't work, you might need a full keyboard replacement.

  4. If the carriage isn't laying flat or it appears to be warped, try gently pressing down on the bent part to see if it will snap back into place.[2]
    • Likewise, if the key cap is tilted or loose, try pressing down on it to see if it snaps back into place.
  5. This includes the carriage and key pad.
    • Be sure to note the position of the internal parts so that you can place them back later.
  6. One of the most common reasons for computer keys failing to work is foreign material in the area beneath the key. If you see any dust or residue, remove it and clean the area.
  7. Place both the carriage and pad back in the key slot in the way in which they were initially set. You may have to press down on parts of the carriage to lock it into place.[3]
  8. Insert the top of the key into the slot at a 45-degree angle, then lower the rest of the key into the slot. This should allow the hooks that are typically at the top of the key to catch when placed.[4]
    • If there aren't hooks at the top of the key, this will still allow the key to come to a naturally horizontal resting position when you lay it down.
  9. This will snap the key back into place. It should spring back up immediately after you remove your finger.[5]
    • If the key is still broken (e.g., it won't spring back up, its letters don't type, etc.), you'll need to replace the key instead.
  10. Advertisement
Part 3
Part 3 of 3:

Replacing a Key

PDF download Download Article
  1. Type your computer's manufacturer name and model number, followed by replacement key, into Google and review the results.
    • For example, you might type asus q553ub replacement key into Google.
  2. Depending on your model of computer and your regional location, your options for ordering keys will vary.
    • Places like eBay, Amazon, Best Buy, and many other online stores stock key replacements.
  3. As with repairing the key earlier, make sure that you are aware of the key's parts' location before removing them so that you have a reference.[6]
    • If you can take a reference picture before removing the key's internal parts, do so.
  4. It should be positioned in exactly the same way in which the former carriage was positioned.[7]
  5. Push the key pad into the center of the carriage, then press down until it clicks or snaps into the carriage.
    • Skip this step on a MacBook or any other keyboard that doesn't use key pads.
  6. Insert the top of the key into the slot at a 45-degree angle, then lower the rest of the key into the slot.
  7. The key should snap into place, and it should spring up immediately after you remove your finger.
    • Test your key before you throw away your receipt.
  8. Advertisement

Community Q&A

Search
Add New Question
  • Question
    I successfully reattached the key, but now it doesn't register on the screen when it's pressed, although it feels 'right' to the touch. What do l need to do?
    Community Answer
    Community Answer
    First, take the key - you should see a small white button underneath. Press it. If it doesn't respond, you need a new key. If it does work, make sure the key is perfectly aligned with the button.
  • Question
    I put the key on and only half remains on; the other half just lifts. What do I do?
    Community Answer
    Community Answer
    Completely remove the key. Put the lose side in the slot, then click the other side in.
  • Question
    The key isn't completely going in. Any reason why?
    Community Answer
    Community Answer
    You need to completely remove the key and put the bottom on first. Next clip, the top on.
See more answers
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement

Video

Tips

  • Not all keyboards are alike, so make sure that the model of key that you get works for your specific model of computer by researching it as much as possible before purchasing.
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement

Warnings

  • If your key still won't work after being replaced, your keyboard's circuit board is most likely the problem. Having a laptop circuit board replaced is generally a task best left to a tech department (e.g., the Apple Store or a place like Best Buy).
Advertisement

You Might Also Like

Fix a Jammed Keyboard Key5 Ways to Unstick a Keyboard Key on Computer or Laptop
Fix a Keyboard That Has the Wrong CharactersFix a Keyboard That Has the Wrong Characters
Pop a Key Back Onto a Dell Laptop Keyboard6 Easy Steps to Replacing or Fixing a Dell Laptop Keyboard Key
Enter the BIOS on a Lenovo Laptop4 Easy Ways to Enter the BIOS on a Lenovo Laptop
Dell Laptop Black Screen11 Simple Ways to Fix a Dell Laptop with a Black Screen
Reformat a LaptopReformat a Laptop
Keep Your Laptop from Overheating10 Simple Ways Keep Your Laptop from Overheating
Check the Temperature of Your LaptopCheck the Temperature of Your Laptop
Save a Laptop from Liquid DamageWhat to Do If You’ve Spilled Water on Your Laptop
Lenovo Laptop Black Screen10 Simple Ways to Fix a Lenovo Laptop with a Black Screen
Fix Screen Bleeding on LaptopSimple Steps to Solve Screen Bleeding on Laptop
Reset a Toshiba Laptop Reset Any Toshiba Laptop: A Step-by-Step Guide
Fix a Laptop ScreenFix a Laptop Screen
Take Good Care of Your Laptop ComputerTake Good Care of Your Laptop Computer
Advertisement

About This Article

Mobile Kangaroo
Co-authored by:
Computer & Phone Repair Specialists
This article was co-authored by Mobile Kangaroo and by wikiHow staff writer, Jack Lloyd. Mobile Kangaroo is a full service repair shop and Apple Authorized Service Provider headquartered in Mountain View, CA. Mobile Kangaroo has been repairing electronic devices such as computers, phones, and tablets, for over 19 years, with locations in over 20 cities. This article has been viewed 549,335 times.
How helpful is this?
Co-authors: 19
Updated: April 3, 2024
Views: 549,335
Thanks to all authors for creating a page that has been read 549,335 times.

Is this article up to date?

Advertisement